Nail for the size of the air pressure, according to the object of the material and the size of the nail, setting the ideal low pressure air pressure to start, gradually increase the pressure, until you reach satisfactory result Nail Making Machine manufacturers of nailing. Before using the tool, check the air pressure, absolutely not exceed the prescribed pressure, otherwise may cause blowout of tools, rapid nailing must keep air pressure needed for the nail gun, or underpowered can't running. Air must use dry, clean compressed air, oxygen and is strictly prohibited any flammable gas, lest cause accident harm.
When volume nail gun and connecting the trachea, nailing unless, otherwise do not withhold machine, lest cause accident, and in every time after work, be sure to separate pneumatic tube and tools.
Coil nail machine manufacturers to remind us that must use the coil nail machine according to specification, to prevent the occurrence of problem, when using mainly pay attention to what aspects? To pay attention to the inspection for coil nail gun screw tightness, do not touch the trigger, outside the nailing gun absolutely not the people. Must use the specified nails, gun must be nailed on. When packing nails or operating wire nail machine manufacturers roll machine guns, hand or body is placed where the nail is likely to be hit. Not nailing in the edge of a crucified, crucified on the corner or too thin, after the nail into the not again on the nailing, and at the end of the work must take out the nail box or a gun in the mouth of the rest of the nail. Use tap safety device, must often check the safety device is normal.
When working in the outdoor or of higher, in the roof or tilted operation volume nail gun, must from the progressive move up homework, reverse direction operation will be in danger of falling.
In volume nail machine use process, if the card the phenomenon of nail, coil nail, vendors would remind us that should find out the specific reason, can better solution.
One reason is that the nail is not standard, this request must be selected according to nail gun specification standard. It is possible that the pin roll deformation or bending, this can pull nails volume, level off after straightening, nail Nail machine manufacturer plate again. And then there is need to check whether the firing pin head wear, replace the piston assembly solution; Check whether nail head wear, have the wear need to timely change the nail head; And check whether more inside the head screw, remove the nail.
Nail nail and nail gun card after annealing method, is to pull the gas source, press the opening and closing pin and open the cover plate and screw the lid, take out the nail, with iron rods, 3-5 mm on the nail tip, with iron lamented under lightly.