CNC machine tools is a kind of using computer to adjust, is type variety, large processing parts Small batch, desultorily, precision problem important way. We should die casting parts pay attention to the following problems after processing, to ensure that the machine tool and employee safety.
Processing machine to remove waste, after cleaning, maintenance cleaning machine tools and machine tool the internal of the natural environment, pay attention to check the machine tool slide to wipe the oil on board, if there is damage to immediately moved around. After processing is to query with the condition of the cooling liquid grease Immediately, and guarantee enough grease and coolant. Close the actual operation on the control panel power and total power. Processing and ensure workers safety during the whole process, be sure to after clamping workpiece and tool, the next step work.
Work, ban Halfway within the machine tool work plan on adjusting tool and machining, the technician can be carried out only after shutdown conversion or adjust the cutting tool and workpiece. Should be cleaning the machine after processing to surrounding environment, keep clean, to pull the tailstock and the plate to the end of a machine tool And shut off the power. Machine tool on the safety protective equipment, the technician is literally disassembling and conversion, after processing of machine parts and tooling fixture properly stored, keep intact, worn out or Investment casting parts destroyed to fill immediately. Machine tool if there is abnormal Condition should be immediately shut down, maintenance on the spot, circular machine maintenance management personnel, technicians it is forbidden to change main parameters of the machine.
Before conducting CNC processing, each mechanical equipment before work should be careful processing parts if there is a note to add grease, then can start 1-3 minutes to check whether all normal work, if Common faults it is forbidden to actual operation. There are, in the operation process, the attitude to the right, good abundant spirit work, human body if there is discomfort immediately leave jobs, and with the leading cadre. Prevent accidents and dress code Also need to mark;
Times, power conversion processing mould first, introduction to mechanical equipment to terminate running again after installation, adjust the mould, after assembling, manual pump flywheel tried a few times, inspection, die bei is symmetry about screw is tight, and the circle If put on site. One of the most important is to must wait all leave to run the die casting parts power switch, work gradually, remember that after startup, cannot be reached into the work area, put in stamping die, product application artifacts must be specifically dedicated Tools, if any abnormal noise or equipment failure, immediately shut off the power, after the termination of the operation to inspect common faults. Off work ought to turn off the switch power supply, combed the manufactured goods, on the job side of the foot with dirt, clear good security And environmental health.
6 Blog posts